Displaying Controls parts for the Briggs and Stratton 135232-0179-03

Find a full parts listing for all the parts in the Controls section of your equipment and add them straight to your cart from here.
Search by part description:
216

Briggs and Stratton 691824

Link-Choke

(Manual)

Your price: $6.08

0 of these in your cart

Qty:
226A

Briggs and Stratton 399109

Rod-Choke

(Rod Assembly)

Your price: $16.13

0 of these in your cart

Qty:
227

Briggs and Stratton 690653

Lever-Governor Control

Your price: $7.09

0 of these in your cart

Qty:
367

Briggs and Stratton 691660

Screw

(Wire Clip)

Your price: $2.98

0 of these in your cart

Qty:
404

Briggs and Stratton 691691

Washer

(Governor Crank)

Your price: $3.60

0 of these in your cart

Qty:
485

Briggs and Stratton 692295

Knob-Control

(Slide)

Your price: $6.26

0 of these in your cart

Qty:
485A

Briggs and Stratton 391908

Knob-Control

(Round)

Your price: $7.26

0 of these in your cart

Qty:
505

Briggs and Stratton 691251

Nut

(Governor Control Lever)

Your price: $3.45

0 of these in your cart

Qty:
562

Briggs and Stratton 691119

Bolt

(Governor Control Lever)

Your price: $3.92

0 of these in your cart

Qty:
614

Briggs and Stratton 691620

Pin-Cotter

Your price: $3.87

0 of these in your cart

Qty:
615

Briggs and Stratton 93307

Retainer-Governor Shaft

Your price: $4.66

0 of these in your cart

Qty:
616

Briggs and Stratton 692016

Crank-Governor

Your price: $20.00

0 of these in your cart

Qty:
620

Briggs and Stratton 490649

Panel-Speed Control

Not available
621

Briggs and Stratton 692310

Switch-Stop

Your price: $4.26

0 of these in your cart

Qty:
688

Briggs and Stratton 690395

Cap-Friction

Your price: $4.26

0 of these in your cart

Qty:
689A

Briggs and Stratton 690529

Spring-Friction

(Hand Choke Control)

Your price: $7.26

0 of these in your cart

Qty:
729A

Briggs and Stratton 690471

Clip-Wire

(NO LONGER AVAILABLE)

Not available
1197

Briggs and Stratton 92484

Screw

(Hand Choke Rod)

Your price: $3.60

0 of these in your cart

Qty:

4-Cycle Equipment

A basic spring service performed each year should include, at least, the following;
Check the Oil and inspect for contaminants such as water (milky), fuel (too full, thin and smells of gas) or metal particles. Contact a service tech if any are found.
Change your oil now and every 25 hours thereafter.
Sharpen blades now and every 25 hours thereafter.
Inspect air filters for dirt accumulation now, and before each usage and clean or replace. Replace air filters after 25 hours.
Inspect spark plugs every 25 hours and replace if fouled.
Grease all bearings and mechanisms requiring grease.
Inspect entire unit including all wear items such as belts, tires, control cables, bearings and other parts and watch for worn, cracked, pinched or otherwise damaged parts, and replace if found.
Drain fuel from fuel system and replace with fresh fuel if it has been over three months since last usage without fuel stabilizer. If performing and end-of-season service, drain fuel tank or run engine until it runs out of fuel. (alternatively you may dose "fresh" fuel with a fuel stabilizer)