Displaying Gas Tank Assembly parts for the B&S Power Products (Generac) 0765-1 - 2,600 PSI

Find a full parts listing for all the parts in the Gas Tank Assembly section of your equipment and add them straight to your cart from here.
Search by part description:
51

B&S Power Products (Generac) 95549

FUEL TANK CAP

Not available
52

B&S Power Products (Generac) 94994

1-GALLON FUEL TANK

Not available
53

B&S Power Products (Generac) 96001

SHIELD BOLT

Not available
54

B&S Power Products (Generac) 96002

TANK BUSHING

Not available
55

B&S Power Products (Generac) 83512

M8 x 15mm TAPTITE SCREW

Not available
56

B&S Power Products (Generac) 21545

HEAT SHIELD

Not available
57

B&S Power Products (Generac) 95213

TANK BRACKET

Not available
58

B&S Power Products (Generac) 77395

M6 FLANGE NUT

Not available
59

B&S Power Products (Generac) 95214

TANK CRADLE

Not available
60

B&S Power Products (Generac) 30340

1/4" DIA. x 12" HOSE

Not available
61

B&S Power Products (Generac) 48031C

HOSE CLAMP

Not available
62

B&S Power Products (Generac) 96193

SHUT-OFF VALVE

Not available
63

B&S Power Products (Generac) 30340

1/4" DIA. x 2" HOSE

Not available

2-Cycle Equipment

A basic spring service performed each year should include, at least, the following;
Sharpen or Replace and Adjust Chain (chainsaw) as needed.
Inspect air filter for dirt accumulation now, and before each usage and clean or replace. Replace air filter after 25 hours.
Inspect spark plug/s every 25 hours and replace if fouled.
Inspect entire unit including all wear items such as control cables, sprockets, handles, tubes and other parts and watch for worn, cracked, pinched or otherwise damaged parts, and replace if found.
Drain fuel-mix from fuel system and replace with fresh fuel-mix if it has been over three months since last usage without fuel stabilizer. If performing and end-of-season service, drain fuel tank or run engine until it runs out of fuel. (alternatively you may dose "fresh" fuel-mix with a fuel stabilizer)