Displaying Electric Start parts for the MTD 12A-459B120 (2002)

Find a full parts listing for all the parts in the Electric Start section of your equipment and add them straight to your cart from here.
Search by part description:
1

MTD 725-0201

Ignition Key

If equipped

Not available

Cub Cadet 925-0201

Alternative for 725-0201: IGNITION KEY SET OF T

Your price: $5.53

0 of these in your cart

Qty:
2

MTD 725-0873

Key Switch

If equipped

Not available

Cub Cadet 925-0873

Alternative for 725-0873: SWITCHKEY

Your price: $15.20

0 of these in your cart

Qty:
3

MTD 731-0891A

Battery Tray

If equipped

Your price: $16.13

0 of these in your cart

Qty:
4

MTD 725-0727

Battery Charger

If equipped

Not available

Cub Cadet 925-0727

Alternative for 725-0727: BATTERY CHARGER

Your price: $43.31

0 of these in your cart

Qty:
5

MTD 725-0298

Fuse 7.5 Amp

If equipped

Not available

Cub Cadet 925-0298

Alternative for 725-0298: FUSE7.5 AMP

Your price: $2.55

0 of these in your cart

Qty:
6

MTD 725-1428

Fuse Holder

If equipped

Not available

Cub Cadet 925-1428

Alternative for 725-1428: HOLDERFUSE

Your price: $14.24

0 of these in your cart

Qty:
7

MTD 725-1276

Battery 12V

If equipped

Not available

Cub Cadet 925-1276

Alternative for 725-1276: BATTERY PACK 12 VOLT

Your price: $102.05

0 of these in your cart

Qty:
8

MTD 710-0501

Hex Screw:1/4-20:2.0

If equipped

Your price: $3.65

0 of these in your cart

Qty:
9

MTD 736-0270 (replaces 736-0270)

Bell Washer .265 x .75 x .062

If equipped

Your price: $2.17

0 of these in your cart

Qty:
10

MTD 712-0329

Special Hex Nut 5/16-18

If equipped

Not available
11

MTD 725-1206

Plug

If equipped

Not available

Cub Cadet 925-1206

Alternative for 725-1206: PLUG

Your price: $7.89

0 of these in your cart

Qty:
12

MTD 912-3010 (replaces 712-0267)

Nut 5/16-18

If equipped

Your price: $2.26

0 of these in your cart

Qty:
13

MTD 736-0242

Bell Wash .340 ID x .872 OD

If equipped

Your price: $2.26

0 of these in your cart

Qty:
14

MTD 712-0287

Hex Nut 1/4-20

If equipped

Not available

Cub Cadet 912-0287

Alternative for 712-0287: NUTHEX 1420

Your price: $2.40

0 of these in your cart

Qty:
15

MTD 710-1250

Carriage Bolt 5/16-18 x 1

If equipped

Your price: $2.44

0 of these in your cart

Qty:
16

MTD 710-0111

Carriage Screw

If equipped

Your price: $1.90

0 of these in your cart

Qty:
17

MTD 782-9012

Lower Battery Tray

If equipped

Not available

Cub Cadet 782-9012-0637

Alternative for 782-9012: BLACK BATTERY TRAY

Your price: $15.71

0 of these in your cart

Qty:
18

MTD 710-0969

Tapp Screw

If equipped

Your price: $2.35

0 of these in your cart

Qty:
19

MTD 725-1538

Harness Extension

If equipped

Your price: $13.31

0 of these in your cart

Qty:
20

MTD 625-0022

Harness

If equipped

Not available

Cub Cadet 925-1442

Alternative for 625-0022: WIRE HARNESS

Your price: $52.37

0 of these in your cart

Qty:

4-Cycle Equipment

A basic spring service performed each year should include, at least, the following;
Check the Oil and inspect for contaminants such as water (milky), fuel (too full, thin and smells of gas) or metal particles. Contact a service tech if any are found.
Change your oil now and every 25 hours thereafter.
Sharpen blades now and every 25 hours thereafter.
Inspect air filters for dirt accumulation now, and before each usage and clean or replace. Replace air filters after 25 hours.
Inspect spark plugs every 25 hours and replace if fouled.
Grease all bearings and mechanisms requiring grease.
Inspect entire unit including all wear items such as belts, tires, control cables, bearings and other parts and watch for worn, cracked, pinched or otherwise damaged parts, and replace if found.
Drain fuel from fuel system and replace with fresh fuel if it has been over three months since last usage without fuel stabilizer. If performing and end-of-season service, drain fuel tank or run engine until it runs out of fuel. (alternatively you may dose "fresh" fuel with a fuel stabilizer)