Displaying Gear Case parts for the Murray 536.881550 - Craftsman Dual Stage Snow Thrower (2004)

Find a full parts listing for all the parts in the Gear Case section of your equipment and add them straight to your cart from here.
Search by part description:
300

Murray 10577

CASE, GEAR, RH

Not available
301

Murray 10576

CASE, GEAR, LH

Not available
303

Murray 710025

SCREW

Not available
304

Murray 15X143

NUT

Not available
306

Murray 9344

SCREW

Not available
310

Murray 9566

SEAL, OIL

Not available
311

Murray 50304

BEARING, FL

Not available
312

Murray 48275

WASHER, FLAT

Not available
313

Murray 1501189

SHAFT, OUTPUT

Not available
314

Murray 51279

GASKET

Not available
315

Murray 51405

GEAR, WORM

Not available
316

Murray 431787

KEY, WOODRUFF

Not available
320

Murray 50221

BRNG, FL

Not available
321

Murray 1501191

SHAFT, INPUT

Not available
322

Murray 580295

COLLAR, THRUST

Not available
323

Murray 454565

PIN, SPRING

Not available
324

Murray 48275

WASHER, FLAT

Not available
325

Murray 50684

BRNG, ROLL

Not available
326

Murray 50304

BRNG, FL

Not available
327

Murray 9566

SEAL, OIL

Not available
340

Murray 1501188E701

IMPELLER

Not available
341

Murray 454565

PIN, SPRING

Not available
*

Murray 333431

10oz LUBRICATION

(Not Illustrated)

Not available

2-Cycle Equipment

A basic spring service performed each year should include, at least, the following;
Sharpen or Replace and Adjust Chain (chainsaw) as needed.
Inspect air filter for dirt accumulation now, and before each usage and clean or replace. Replace air filter after 25 hours.
Inspect spark plug/s every 25 hours and replace if fouled.
Inspect entire unit including all wear items such as control cables, sprockets, handles, tubes and other parts and watch for worn, cracked, pinched or otherwise damaged parts, and replace if found.
Drain fuel-mix from fuel system and replace with fresh fuel-mix if it has been over three months since last usage without fuel stabilizer. If performing and end-of-season service, drain fuel tank or run engine until it runs out of fuel. (alternatively you may dose "fresh" fuel-mix with a fuel stabilizer)