Displaying Spindle Assembly parts for the Snapper 421618BVE (84264) 42" 16 HP Rear Engine Rider Series 18

Find a full parts listing for all the parts in the Spindle Assembly section of your equipment and add them straight to your cart from here.
Search by part description:
1

Snapper 7059628BMYP (replaces 7059628)

ASSEMBLY, Spindle Housing

(Includes items 2 thru 8)

Your price: $156.13

0 of these in your cart

Qty:
2

Snapper 7012491SM (replaces 7012491)

RING, 1.75" Internal Retaining

Your price: $1.68

0 of these in your cart

Qty:
3

Snapper 7013313

BEARING, Spindle

Not available

Snapper 2108202SM

Alternative for 7013313: BEARING BALL

Your price: $6.65

0 of these in your cart

Qty:
4

Snapper 7051469YP (replaces 7051469)

HOUSING, Spindle (7.5" high)

Was 47849

Your price: $51.76

0 of these in your cart

Qty:
5

Snapper 7010817SM (replaces 7010817)

FITTING, Lube (Press fit for .187 hole-no ball)

Your price: $1.68

0 of these in your cart

Qty:
6

Snapper 7032294YP (replaces 7032294)

HOLDER, Blade

Your price: $18.39

0 of these in your cart

Qty:
7

Snapper 7014407SM (replaces 7014407)

WASHER, Spindle

Your price: $3.13

0 of these in your cart

Qty:
8

Snapper 7027640YP (replaces 7027640)

SPINDLE (9.5" Long)

Your price: $51.15

0 of these in your cart

Qty:
9

Snapper 7012670YP (replaces 7012670)

RING, Tolerance (.75" high)

Your price: $4.75

0 of these in your cart

Qty:

4-Cycle Equipment

A basic spring service performed each year should include, at least, the following;
Check the Oil and inspect for contaminants such as water (milky), fuel (too full, thin and smells of gas) or metal particles. Contact a service tech if any are found.
Change your oil now and every 25 hours thereafter.
Sharpen blades now and every 25 hours thereafter.
Inspect air filters for dirt accumulation now, and before each usage and clean or replace. Replace air filters after 25 hours.
Inspect spark plugs every 25 hours and replace if fouled.
Grease all bearings and mechanisms requiring grease.
Inspect entire unit including all wear items such as belts, tires, control cables, bearings and other parts and watch for worn, cracked, pinched or otherwise damaged parts, and replace if found.
Drain fuel from fuel system and replace with fresh fuel if it has been over three months since last usage without fuel stabilizer. If performing and end-of-season service, drain fuel tank or run engine until it runs out of fuel. (alternatively you may dose "fresh" fuel with a fuel stabilizer)