Displaying Discharge Chute parts for the Snapper EI55224 22" 5.5 HP Two Stage Intermediate Snow Thrower Euro Series 4

Find a full parts listing for all the parts in the Discharge Chute section of your equipment and add them straight to your cart from here.
Search by part description:
1

Snapper 7053411YP (replaces 7053411)

ASSEMBLY, Discharge Chute

(Includes Item 2)

Your price: $60.23

0 of these in your cart

Qty:
2

Snapper 7024773YP (replaces 7024773)

DECAL, Danger

Your price: $7.90

0 of these in your cart

Qty:
?2A

Snapper 7028700SM (replaces 7028700)

DECAL, Read Manual (Euro)

Your price: $9.08

0 of these in your cart

Qty:
3

Snapper 7029847YP (replaces 7028184)

DEFLECTOR, Discharge Chute

Your price: $9.46

0 of these in your cart

Qty:
4A

Snapper 703065 (replaces 7035744)

T-KNOB (Plastic)

Was 16324

Your price: $5.45

0 of these in your cart

Qty:
4B

Snapper 7035744

T-KNOB (w/5/16-18 insert)

Not available

Snapper 703065

Alternative for 7035744: WINGKNOB 51618

Your price: $5.45

0 of these in your cart

Qty:
5

Snapper 7028253YP (replaces 7028253)

PIN, Hinge

Your price: $6.24

0 of these in your cart

Qty:
6

Snapper 7038205YP (replaces 7038205)

RING, Chute

Your price: $16.50

0 of these in your cart

Qty:
7

Snapper 7011938SM (replaces 7011938)

RETAINER (Chute Ring to Housing)

Your price: $4.24

0 of these in your cart

Qty:
8

Snapper 7091075SM (replaces 7091075)

SCREW, #10-24 x 5/8" Hex Washer Self-Tapping

Your price: $3.60

0 of these in your cart

Qty:
9

Snapper 7091077YP (replaces 7091077)

BOLT, 5/16-18 x 5/8" Square Neck Carriage, Grade 5

Your price: $4.14

0 of these in your cart

Qty:
10

Snapper 703409 (replaces 7091601)

NUT, 5/16-18 Hex Flange Lock, Grade 5

Was 91070

Your price: $4.91

0 of these in your cart

Qty:
11

Snapper 7090316SM (replaces 7090316)

BOLT, 5/16-18 x 3/4" Square Neck Carriage, Grade 5

Was 91097

Your price: $2.74

0 of these in your cart

Qty:
12

Snapper 703350 (replaces 7091076)

WASHER, 5/16 Flat

Your price: $3.54

0 of these in your cart

Qty:
13

Snapper 7091511SM (replaces 7091511)

NUT, 5/16-18 Hex, Grade B or 5

Was 90196

Your price: $2.74

0 of these in your cart

Qty:
14

Snapper 7091021YP (replaces 7091021)

SCREW, 5/16-24 x 3/4" Hex Head Cap, Grade 5

Your price: $2.74

0 of these in your cart

Qty:
15

Snapper 7091606SM (replaces 7091606)

NUT, 5/16-24 Hex Center Lock, Grade B

Was 91074

Not available

Snapper 703896

Alternative for 7091606SM: NUT HEX 51624

Your price: $2.74

0 of these in your cart

Qty:
16

Snapper 7091552SM (replaces 7091552)

WASHER, 7/32 Flat

Your price: $3.17

0 of these in your cart

Qty:
17

Snapper 7019692SM (replaces 7019692)

WIRE, Safety (Euro)

Your price: $16.17

0 of these in your cart

Qty:
18

Snapper 7023673YP (replaces 7023673)

PUSH-ON Fastener, .5/32" Dia. (Euro)

Your price: $2.74

0 of these in your cart

Qty:
19

Snapper 7032559YP (replaces 7032559)

RETAINER, Safety Wire (Euro)

Your price: $9.08

0 of these in your cart

Qty:

2-Cycle Equipment

A basic spring service performed each year should include, at least, the following;
Sharpen or Replace and Adjust Chain (chainsaw) as needed.
Inspect air filter for dirt accumulation now, and before each usage and clean or replace. Replace air filter after 25 hours.
Inspect spark plug/s every 25 hours and replace if fouled.
Inspect entire unit including all wear items such as control cables, sprockets, handles, tubes and other parts and watch for worn, cracked, pinched or otherwise damaged parts, and replace if found.
Drain fuel-mix from fuel system and replace with fresh fuel-mix if it has been over three months since last usage without fuel stabilizer. If performing and end-of-season service, drain fuel tank or run engine until it runs out of fuel. (alternatively you may dose "fresh" fuel-mix with a fuel stabilizer)